Size
44
Series
PACS
Category of safety footwear
SBP
Top material
leather, plastic mesh
sole material
PU
Anti-puncture material
Plastic
Steel nose
Yes
compressive load
15 kN
impact energy
200J
Non-slip sole
Yes
Slip resistance
SRA
Clasp type
laces
Standard
EN ISO 20345:2011
Penetration resistance of the sole
1100N
The length of the insert
29.0 cm
foot length
28.7 cm
Insert material
EVA, foam

Working shoes from the PACS SB P series are designed for high comfort during long hours of work in dry conditions. They will protect both the toes and the bottom of the foot against serious injury.

The airy upper, lined from the inside with a material with a sponge, ensures air circulation and a pleasant fit to the upper part of the foot. The sole made of innovative polyurethane foam with an air cushion under the heel and a special foam insole cushion the foot very well. The foam insole perfectly supports the toes, midfoot and heel, it is 10 mm thick at its thickest point.

Protection against puncture of the sole is guaranteed by a flexible, 4 mm thick protective insert made of the material used for the production of bulletproof vests. Fingers are protected by an impact-resistant steel toe cap.

Basic information:

upper material: AIR MESH
sole material: polyurethane
Foot protection:

category: SB P
slip resistance: SRA
steel toecap resistant to impacts with energy up to 200 J and crushing up to 15 kN
composite anti-puncture insole that protects the foot from the ground against piercing with sharp elements with pressure up to 1100 N
insole with foam with increased comfort, in the thickest place it is as much as 10 mm.
non-slip and flexible PU sole
Additional information:

built-up heel area with additional material resistant to abrasion
compliance with the requirements of the EN 20345 standard